A simple model of EMI-induced timing jitter in digital circuits, its statistical distribution and its effect on circuit performance

A simple model has been developed to characterize electromagnetic interference induced timing variations (jitter) in digital circuits. The model is based on measurable switching parameters of logic gates, and requires no knowledge of the internal workings of a device. It correctly predicts not only the dependence of jitter on the amplitude, modulation depth and frequency of the interfering signal, but also its statistical distribution. The model has been used to calculate the immunity level and bit error rate of a synchronous digital circuit subjected to radio frequency interference, and to compare the electromagnetic compatibility performance of fast and slow logic devices in such a circuit

The use of coconut oil/diesel blends as a fuel for compression ignition engines (ODNRI Bulletin No. 31)

This bulletin describes experimental and evaluative work carried out by the Overseas Development Natural Resources Institute (ODNRI) to investigate fuelling of a standard compression ignition engine with blends of coconut oil and diesel. Initial studies were made of fuel-related properties for pure coconut oil and for a full range of blends with diesel. A major upgrading of the standard engine's fuel filtration system was necessary but thereafter it was found that a blend of 80% coconut oil in diesel, when heated to 45°C, provided a technically feasible substitute fuel. A limited duration engine trial was completed with this alternative arrangement to assess maintenance and operational requirements. On the basis of these results a preliminary economic evaluation was made of the potential for wider adoption of this type of substitute fuelling. Whilst this indicated that at prevailing prices of coconut oil relative to diesel this was unattractive, circumstances were identified in which this technology could have potential application

Design, synthesis and characterization of linear unnatural amino acids for skin moisturization

Objectives This work aimed to design, synthesize and characterize replacement natural moisturizing factor (NMF) composed of modified hygroscopic linear amino acids to pre-empt or repair skin barrier dysfunction. Methods Following synthesis and characterization, thermo-gravimetric analysis and quantum mechanics molecular modelling quantified and depicted water binding to the new compounds. Deliquescence relative humidity demonstrated the water-scavenging ability of the compounds, whereas snake skin moisturizing studies showed they increased water uptake into snake skin. Results From thermal analysis, N-hydroxyglycine showed greatest water-holding capacity followed by N-hydroxyserine, l-homoserine and α-hydroxyglycine; coupled with quantum mechanics molecular modelling, between 8 and 12 molecules of water could associate with each molecule of either N-hydroxyglycine, N-hydroxyserine or l-homoserine. All of our modified amino acids were efficacious and induced similar or greater water uptake compared with the established moisturizing compounds hyaluronic acid, glycerine and urea in snake skin. Incorporated at 10% in Oilatum, N-hydroxyserine induced >200% greater moisture uptake into dry snake skin compared to treatment with water alone, with efficacy related to the molecule structure and ability to bind to 12 water molecules. Oilatum cream spiked with all our unnatural amino acid hydrotropes increased water uptake into snake skin compared with Oilatum alone. The compound series was designed to elucidate some structure – efficacy relationships. Amino acid chirality did not affect the water-holding capacity but did affect uptake into skin. Compounds with high melting points and bond energies tended to decrease water-holding capacity. With isosteric replacement, the more electronegative atoms gave greater water-holding capacities. Conclusions This work demonstrates the potential of unnatural amino acid hydrotropes as skin moisturizers and has developed some predictive ‘rules’ for further design and refinement of chemical structures

Effect of logic family on radiated emissions from digital circuits

Radiated emissions were measured for simple digital circuits designed to operate with various logic families. Emissions in the near and far field were found to depend both on the circuit layout and the choice of logic family. However, the difference in peak emissions between any two logic families was found to be independent of circuit layout. The greatest difference in peak emissions was between high-speed 74ACT logic and low-speed 4000 CMOS logic devices, with a mean value of approximately 20 dB. Emissions from a more complex circuit were compared with the measurements on simple loop circuits. Test circuits were used to measure the propagation delay, the rise and fall times, the maximum operating frequency and the transient switching currents between two successive logic gates for each logic family. Empirical formulas have been derived that relate relative peak emissions to these switching parameters. It is hoped that these will assist designers to assess the effect of choice of logic family on electromagnetic compatibility

Performance of 20:1 multiplexer for large area charge readouts in directional dark matter TPC detectors

More target mass is required in current TPC based directional dark matter detectors for improved detector sensitivity. This can be achieved by scaling up the detector volumes, but this results in the need for more analogue signal channels. A possible solution to reducing the overall cost of the charge readout electronics is to multiplex the signal readout channels. Here, we present work on an expanded LMH6574 multiplexer system with a capability of reducing the number of readouts in such TPC detectors by a factor of 20. Results indicate that the important charge distribution asymmetry along an ionization track is retained after multiplexed signals are demultiplexed

Three-dimensional stability of Burgers vortices

Burgers vortices are explicit stationary solutions of the Navier-Stokes equations which are often used to describe the vortex tubes observed in numerical simulations of three-dimensional turbulence. In this model, the velocity field is a two-dimensional perturbation of a linear straining flow with axial symmetry. The only free parameter is the Reynolds number $Re = \Gamma/\nu$, where $\Gamma$ is the total circulation of the vortex and $\nu$ is the kinematic viscosity. The purpose of this paper is to show that Burgers vortex is asymptotically stable with respect to general three-dimensional perturbations, for all values of the Reynolds number. This definitive result subsumes earlier studies by various authors, which were either restricted to small Reynolds numbers or to two-dimensional perturbations. Our proof relies on the crucial observation that the linearized operator at Burgers vortex has a simple and very specific dependence upon the axial variable. This allows to reduce the full linearized equations to a vectorial two-dimensional problem, which can be treated using an extension of the techniques developped in earlier works. Although Burgers vortices are found to be stable for all Reynolds numbers, the proof indicates that perturbations may undergo an important transient amplification if $Re$ is large, a phenomenon that was indeed observed in numerical simulations.Comment: 31 pages, no figur

The Historical Relations of the Papuan Languages of Alor and Pantar

Language Use in Past and Presen

An alternative approach to the construction of Schur-Weyl transform

We propose an alternative approach for the construction of the unitary matrix which performs generalized unitary rotations of the system consisting of independent identical subsystems (for example spin system). This matrix, when applied to the system, results in a change of degrees of freedom, uncovering the information hidden in non-local degrees of freedom. This information can be used, inter alia, to study the structure of entangled states, their classification and may be useful for construction of quantum algorithms.Comment: 6 page

Nonlinear stability of solitons against strong external perturbations

We study soliton stability under the action of strong external perturbations. Limits on the weak perturbation approach are established with the help of average Lagrangian methods and full simulations. We found that for the same relative perturbation, larger amplitude solitons develop instability earlier than weaker amplitude solitons.F. B. Rizzato, G. I. de Oliveira, and A. C.-L. Chia